Fortinet NSE7_EFW-6.4 dumps have been updated with 115 Fortinet NSE 7 – Enterprise Firewall 6.4 Exam questions and answers, verified by industry experts.
Candidates for Fortinet NSE 7 – Enterprise Firewall 6.4 Exam: Download Fortinet NSE7_EFW-6.4 dumps https://www.leads4pass.com/nse7_efw-6-4.html, practice hard, you are guaranteed 100% success in passing the Fortinet NSE 7 – Enterprise Firewall 6.4 certification exam.
Here you can also enjoy free Fortinet NSE 7 – Enterprise Firewall 6.4 exam practice:
Fortinet NSE 7 – Enterprise Firewall 6.4 Exam Practice:
Tips: Verify the answer at the end of the article
QUESTION 1:
Which real time debug should an administrator enable to troubleshoot RADIUS authentication problems?
A. Diagnose debug application radius -1.
B. Diagnose debug application fnbamd -1.
C. Diagnose authd console -log enable.
D. Diagnose radius console -log enable.
QUESTION 2:
Which of the following statements are true regarding the SIP session helper and the SIP application layer gateway (ALG)? (Choose three.)
A. SIP session helper runs in the kernel; SIP ALG runs as a user space process.
B. SIP ALG supports SIP HA failover; SIP helper does not.
C. SIP ALG supports SIP over IPv6; SIP helper does not.
D. SIP ALG can create expected sessions for media traffic; SIP helper does not.
E. SIP helper supports SIP over TCP and UDP; SIP ALG supports only SIP over UDP.
QUESTION 3:
What does the dirty flag mean in a FortiGate session?
A. Traffic has been blocked by the antivirus inspection.
B. The next packet must be re-evaluated against the firewall policies.
C. The session must be removed from the former primary unit after an HA failover.
D. Traffic has been identified as from an application that is not allowed.
QUESTION 4:
Two independent FortiGate HA clusters are connected to the same broadcast domain. The administrator has reported that both clusters are using the same HA virtual MAC address. This creates a duplicated MAC address problem in the network.
What HA setting must be changed in one of the HA clusters to fix the problem?
A. Group ID.
B. Group name.
C. Session pickup.
D. Gratuitous ARPs.
QUESTION 5:
Which the following events can trigger the election of a new primary unit in a HA cluster? (Choose two.)
A. Primary unit stops sending HA heartbeat keepalives.
B. The FortiGuard license for the primary unit is updated.
C. One of the monitored interfaces in the primary unit is disconnected.
D. A secondary unit is removed from the HA cluster.
QUESTION 6:
View these partial outputs from two routing debug commands:
Which outbound interface will FortiGate use to route web traffic from internal users to the Internet?
A. Both port1 and port2
B. port3
C. port1
D. port2
QUESTION 7:
View the exhibit, which contains the partial output of an IKE real-time debug, and then answer the question below.
Why didn\’t the tunnel come up?
A. The pre-shared keys do not match.
B. The remote gateway\’s phase 2 configuration does not match the local gateway\’s phase 2 configuration.
C. The remote gateway\’s phase 1 configuration does not match the local gateway\’s phase 1 configuration.
D. The remote gateway is using aggressive mode and the local gateway is configured to use man mode.
QUESTION 8:
An administrator is running the following sniffer in a FortiGate:
diagnose sniffer packet any “host 10.0.2.10” 2
What information is included in the output of the sniffer? (Choose two.)
A. Ethernet headers.
B. IP payload.
C. IP headers.
D. Port names.
QUESTION 9:
Refer to the exhibit, which contains partial output from an IKE real-time debug.
Based on the debug output, which phase 1 setting is enabled in the configuration of this VPN?
A. auto-discovery-shortcut
B. auto-discovery-forwarder
C. auto-discovery-sender
D. auto-discovery-receiver
QUESTION 10:
Refer to the exhibit, which contains partial outputs from two routing debug commands.
Why is the port2 default route not in the second command\’s output?
A. It has a higher priority value than the default route using port1.
B. It is disabled in the FortiGate configuration.
C. It has a lower priority value than the default route using port1.
D. It has a higher distance than the default route using port1.
QUESTION 11:
Examine the following traffic log; then answer the question below.
date-20xx-02-01 time=19:52:01 devname=master device_id=”xxxxxxx” log_id=0100020007type=event subtype=system pri critical vd=root service=kemel status=failure msg=”NAT port isexhausted.”
What does the log mean?
A. There is not enough available memory in the system to create a new entry in the NAT port table.
B. The limit for the maximum number of simultaneous sessions sharing the same NAT port has been reached.
C. FortiGate does not have any available NAT port for a new connection.
D. The limit for the maximum number of entries in the NAT port table has been reached.
QUESTION 12:
Which two statements about an auxiliary session are true? (Choose two.)
A. With the auxiliary session setting enabled, ECMP traffic is accelerated to the NP6 processor.
B. With the auxiliary session setting enabled, two sessions will be created in case of routing change.
C. With the auxiliary session setting disabled, for each traffic path, FortiGate will use the same auxiliary session.
D. With the auxiliary session disabled, only auxiliary sessions will be offloaded.
QUESTION 13:
View the exhibit, which contains the output of a debug command, and then answer the question below.
Which of the following statements about the exhibit are true? (Choose two.)
A. In the network on port4, two OSPF routers are down.
B. Port4 is connected to the OSPF backbone area.
C. The local FortiGate\’s OSPF router ID is 0.0.0.4
D. The local FortiGate has been elected as the OSPF backup designated router.
Verify answer:
| Numbers: | Q1 | Q2 | Q3 | Q4 | Q5 | Q6 | Q7 | Q8 | Q9 | Q10 | Q11 | Q12 | Q13 |
| Answers: | B | BCD | B | A | AC | C | C | BC | C | D | B | CD | BC |
[Google Drive] Download the free Fortinet NSE 7 – Enterprise Firewall 6.4 exam questions and answers above: https://drive.google.com/file/d/12YnWC4VQRy4aO4VS20zJJYKGSAKRHDVm/
The free Fortinet NSE 7 – Enterprise Firewall 6.4 exam practice questions will only help you warm up, if you want to pass the Fortinet NSE 7 – Enterprise Firewall 6.4 exam 100%,
Then you should use NSE7_EFW-6.4 dumps https://www.leads4pass.com/nse7_efw-6-4.html to help you get the final victory easily.